This iStick Pico 25 kit features an updated version of the classic Pico vape, along with an ELLO tank and new HW coils. While it may look a lot like the original Pico, there are some important differences that you may find interesting. If you’re considering buying this kit and want to learn everything there is to know about it, read the full review below… Also be sure to check our best online vape store for important information to consider before making your first purchase.
Manufacturing Quality:
The manufacturing quality for the istick pico 25 price is very good, though they could have done a better job with the name! That may seem like a strange thing to mention here, but I actually think the name is the cause of a decent amount of confusion. When there is a number at the end of the name of a vape, it usually corresponds with the amount of watts the mod can output. So in this case, the assumption would be that this version of the Pico can only deliver 25 watts. That assumption would be incorrect though, as the number actually corresponds with the maximum size of the tank that can fit on top, 25 mm! The maximum wattage is 85w.
That complaint has absolutely nothing to do with the actual manufacturing quality though, and the rest of the unit is well built. Like the original Pico, the eleaf istick pico 25 starter kit is smaller than an 18650, so it has to have a cap to hold the battery in place. This also has a special chip that allows the battery to be charged at 2 amps, meaning it will charge faster than many other vapes.
The top-filled ELLO tank comes with the new HW sub-ohm coils and two different drip tips, plus it’s detachable which makes it very easy to clean. The airflow adjusts with a simple twist of the base, and you can also increase the capacity from 2mL to 4mL by swapping out the included glass tubes.
The screen is located along the side of the unit. It’s not very big, but it’s at least crisp and easy to read. The only real complaint I have about the actual manufacturing is the buttons. The up and down buttons are on the bottom, which I find inconvenient, and they also rattle a bit when you shake the mod.
Flavor Quality: The flavor that this kit delivers is also good. The HW1 coil as a single vertical cylinder with a 0.2 ohm coil. The HW1 coil delivers bigger clouds than the HW2, but the flavor isn’t quite as good. It can be used between 40w and 80w, though I found it performed best around 50w.The HW2 coil has two vertical cylinders and 0.3ohm coils. This is the one you want to use if you want maximum flavor, but the clouds won’t be quite as big. It’s maximum wattage is 70w, and I also think it performs best right around 50w like the HW1.
Power Flexibility:The power flexibility is good for such a small unit. You can choose between wattage, temperature control, and bypass modes. The wattage output range is 1-85w, while the temperature range is 200-600F.The resistance range for wattage mode is 0.1-3.5ohm, and for the TC modes it’s 0.05-1.5ohm. Like most vapes, the TC modes include stainless steel, nickel, and titanium, as well as three TCR options.
Ease of Use: This is fairly easy to use. In the manufacturing quality section, I mentioned that I’m not a big fan of the fact that the up and down buttons are located on the bottom of the unit. I prefer to have them closer to the screen because I think the device is easier to use that way.
This also has a traditional fire button rather than a whole side trigger. eleaf tank is extremely easy to clean and fill though, so no complaints there.
We hope you enjoyed reading our iStick Pico 25 review! We would love to hear from you!